Page 160 - REIMO - VAN CONVERSION catalogue
P. 160

3-POINT BELT BUCK



























































        Picture shows universal belt buck 595010 with pad 595005 in Fiat Ducato


        General type approval (ABE)

                  An ABE is an approval that is usually attached to parts that  The vehicle operating permit expires temporarily immediately after
                  are particularly easy to install. It is assumed that the buyer  the conversion until the conversion has been "registered". Only the
                  himself can not do much wrong when mounting these parts  direct way to the TÜV test centre may still be undertaken with the
                  (mostly e.g. rims, etc). Therefore, after performing the modi-  vehicle
                  fication on the vehicle with this part, no further action is
        necessary. The vehicle operating license remains intact and the vehicle can  The TÜV inspector issues a certificate - a registration according to
        continue to be used                                   StVZO §19.3. With this certificate, the modification can then be en-
                                                              tered in the vehicle documents at the registration office. For motor
        However, it must be ensured that all instructions and requirements from  vehicles that had their initial registration before 1.1.1992, there are
        the ABE are observed. The ABE papers must be carried at all times during  no special requirements for modifications to the seat console or seat
        every journey. On request, the information from the ABE can often also be  rails.
        entered in the vehicle documents, so that the ABE no longer has to be car-
        ried separately.                                      Additionally, seat belts were not yet required for motor homes with
                                                              initial registration prior to 1/1/1992. Therefore, no testing is manda-
        TÜV parts certificate A TÜV parts certificate is the most common form of  tory for the installation of swivel bases in these older vehicles. From
        approval for tuning parts. The parts certificate contains precise instructions  the first registration on 1.1.1992, at least an expert opinion accord-
        and conditions. To avoid that tuning parts are attached incorrectly or modi-  ing to 76/115 EWG (Europe-wide ECE R14) must be available when
        fications are carried out incorrectly, the vehicle must be presented to a TÜV  changing the seat structure for approval according to STVZO.
        inspector after the modification. Here, not only the conformity of the certifi-
        cate with the associated part and also the corresponding vehicle type /
        model is checked, but also the quality of the conversion.


      160   www.reimo.com
   155   156   157   158   159   160   161   162   163   164   165